SFOP50M50FL2W 2 " with 2 Rubber Washers

Learn More

Ecov DN150 threaded tank adapter for DWV SW pipe and fittings.  The adapter incorporates a tool connect fitting design and includes one standard screw-cap flat washer and a 10 mm round x 158 mm diameter rubber O'ring for secondary sealing.

The use of this assembly avoids cuting into the side wall of a polyethylene or other tank causing a change in the structurial integrity of the tank and its ground loading effect on its design safety factor.

Learn More

The pump body housing part is a thermoplastic moulded component part of a BPS series pump(s).  As a component part it is easily replacable if damage has been caused in use and otherwise has a considerable lifespan in protected use. 

Learn More

This orifice outlet allows captured stormwater to be released into the public drainage system once a storm event has passed. The orifice can also be configured to provide stormwater infiltaion and to prevent tank flotation in saturated ground. 48 mm is common for on-site retention systems

Learn More

A poly M&F elbow (Hanson) brand that is applied to BSP 25mm threaded pump outlets.  

This type of M&F elbow is multi-purpose for transferring various pipe configurations through 900 to improve the pipe connections from pump equipment outlets.

Learn More

The KS series pumps have a water resistant power lead with socket connector, held inplace with a screwed clamp on the exterior of the pump case. This lead is Type A (with no step O ring seal) and is 10 meter length with Australian three pin plug.

Learn More

This dual pump plumbing kit is used to connect 2 x pumps to a single 50 mm outlet pipe. Each pump has a dedicated check valve that will stop water in the outlet pipe running back into the tank when the pumps switch off and prevent one pump pushing water back into the tank via the second pump. A ball valve allow each pump to be isolated and removed independently. The kit contains: 2 x Barrel Union 2 x M&F Ball Valve 2 x Check Valve 6 x FI Connectors 1 x Back Plated Flange 2 x 90° Elbow 1 x 'T' Piece 2 x Reducers The only additional item required is a suitable length of PCV pipe, which will vary depending of the size of the collection well. An optional dual pump controller is available to manage the pumps and provide an overflow alarm if required Learn More

This float assembly  is used for rainwater tank low-level float control for available water source management by WiWo change-over controller.  This float assembly has a WiWo ELV connector for attachment and for the control end there is a weighted float switch.  The weighted float switch is suspended inside the rainwater tank and indicates that the tank has water available to be pumped to household applications or other industrial processes benefiting from using recycled water. 

Learn More

The major repair to the versatile KS series submersible pump is available using a top-end assembly. The circumstance of the many pump use applications can result in inadvertent damage like crushed or torn cables or float whilst performing in the rugged environment of construction and civil works de-watering on work sites for safety and protection of assets. The KS-10 pump range is a leading product solution in the industry and being well designed for maintenance purposes for the top end of the pump through an authorised service representative. This product assembly provides a means to repair damaged conductor(s) floats and when fitted can restore the operation of the pump for normal use. This assembly product provides some certainty with continued operations having replaced power lead and float components, secured in the inlet glands with a screwed clamp on the exterior of the pump case and then allowing for renewed conductivity and earth leakage testing. Other optional repairs are also available including seal and capacitor replacement on request where a used pump is considered suitable for repair or refurbishment. Learn More