This kit allows large water volumes to be stored by interconecting multiple tanks together. Storage capacity is only limited by the area available for tank installation. The system uses camlok fitting for fast and secure connection.

This kit allows large water volumes to be stored by interconecting multiple tanks together. Storage capacity is only limited by the area available for tank installation. The system uses camlok fitting for fast and secure connection.

This orifice outlet allows captured stormwater to be released into the public drainage system once a storm event has passed. The orifice can also be configured to provide stormwater infiltaion and to prevent tank flotation in saturated ground. 48 mm is common for on-site retention systems

This component part kit is a common union pump outlet fitting with a 50mm threaded socket connection for fast and secure connection typically for polyethylene hose tails or Type F camlock connector.

This orifice outlet allows captured stormwater to be released into the public drainage system once a storm event has passed. The orifice can also be configured to provide stormwater infiltaion and to prevent tank flotation in saturated ground. 48 mm is common for on-site retention systems

This orifice outlet allows captured stormwater to be released into the public drainage system once a storm event has passed. The orifice can also be configured to provide stormwater infiltaion and to prevent tank flotation in saturated ground. 48 mm is common for on-site retention systems

The BPS series pumps have a low level inlet that allows drainage down to 3mm from floor level. This bottom grate is a thermoplastic material that has a long life span that fits into a formed recedd and securred with three stainless screws into the bottom pump chamber housing attached to the pump motor housing. A 5mm side entry grate is available as an option upon request.

The BPS series pumps have a water resistant power lead with socket connector, held inplace with a screwed clamp on the exterior of the pump case. This lead is Type A (with no step O ring seal) and is 10 meter length with Australian three pin plug.

This kit allows large water volumes to be stored by interconecting multiple tanks together. Storage capacity is only limited by the area available for tank installation. The system uses camlok fitting for fast and secure connection.